![]() ![]() ![]() The original module and gauge position sensor electronics are located internally within the VTS housing and are non-serviceable, so when failure occurs, the complete VTS housing must be replaced which requires special tools, and if the repair is not done correctly, water will enter the hull and a catastrophic failure to the craft can occur. You don't even need to remove your vts housing to install the Trimfix. The TrimFix is an easy to install module and sensor that replaces the failed electronics inside the vts housing and eliminating the need to replace your vts housing. With TheTrimFix you will never again replace a bad VTS Housing. VTS housing failure is an extremely common occurrence, and they are too expensive to keep replacing all the time. The TrimFix includes sensor, at no additional cost, to restore gauge operation "Don't waste another penny replacing another failed VTS Housing!" With the TrimFix, there's no need to to replace or even remove your VTS Housing at all! This kit is the SOLUTION for Seadoo trim VTS Housing failure. The TrimFix uses your original factory switch and gauge for a clean install with no unsightly aftermarket addons or alterations Another result of VTS housing failure is the gauge stops working due to the sensor being inside the VTS housing. Item: 233632149123 Seadoo VTS Housing Trim Module and gauge sensor SOLUTION. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |